Camaro Ridetech 4 link cradle

[Pro Touring Store]

Last one I did, also had to make shims to go between the bottom of the rail and the cradle; the bolts would not bring it up, neither would a floor jack. May have sacrificed 1/4" of ride height, but that wasn't a big deal.
It's also best to put some stitch welds in a few areas per side to help rigidity.

-Dale

[Vegas69]

Originally Posted by Pro Touring Store

Last one I did, also had to make shims to go between the bottom of the rail and the cradle; the bolts would not bring it up, neither would a floor jack. May have sacrificed 1/4" of ride height, but that wasn't a big deal.
It's also best to put some stitch welds in a few areas per side to help rigidity.

-Dale

I agree with this philosophy. Mine was fully welded into the frame and I ended up cracking the frame right where it was welded. Those rails are super thin.

[srode1]

Originally Posted by Vegas69

I agree with this philosophy. Mine was fully welded into the frame and I ended up cracking the frame right where it was welded. Those rails are super thin.

were those the original rails?

[Vegas69]

Correct, but they were in mint condtion.

[rickpaw]

Mine dropped right in. I used the provided screws to snug up the cradle, and stitched weld a few spots around the sides.