2nd Chance Camaro - Let the Project Begin - Lateral-g Forums

**syborg tt** · #1 10-04-2022, 01:13 PM

So have you ever had that feeling that you didn't torque something correctly so just to be safe I rechecked everything
and good news it was correct.

It's starting to feel real as I am finally connecting the fuel line to the fuel rail.

**syborg tt** · #2 10-04-2022, 01:22 PM

I know it's not needed but I have gone this far so why stop now.

Not going to lie a couple of these where a bitch to get to.

Remy had no interest in what I was doing so he decided to take a nap.

If you look really close you can see the Lokar Black Dipstick.

Driveshaft is back from the Pro Tek Powder Coating.

So don't ask me where this grommet came from as I would love to have another one.

I think it makes the wire loom exit look much cleaner.

Without.

Where do I get a dust cover for this or do I have to make something ?

Jimbo1367 · #3 10-04-2022, 01:58 PM

Geeeeesh. More ARP SS bolts. Go figure. LOL I dig them myself. Just have to many other things looking for $$$

Trans close out panels:
Dealer. I seen the part numbers listed on LS1tech a while back. I’ll have to check into it

**syborg tt** · #4 10-05-2022, 12:58 PM

Quote:

Originally Posted by Jimbo1367

Geeeeesh.
Trans close out panels:
Dealer. I seen the part numbers listed on LS1tech a while back. I’ll have to check into it

Found them - Thank you so much

Part # 24261714 - Drivers Side
Part # 24261712 - Passenger Side

**syborg tt** · #5 10-05-2022, 02:07 PM

I am finally getting closer to starting this car so I need to start making sure all of the lines are tight.

I have to remake one of the AC lines so today was the perfect day.

Note to Self...Next time I will take the tire off.

Next time I will take the blue tape off the fitting prior to crimping.

**syborg tt** · #6 10-05-2022, 02:19 PM

So, I had a little bit of free time so I decided I would install the U-Joints and put the driveshaft in. Well, that didn't go so well
as I couldn't get the U-Joint seated. I was able to install the axle side with no issue's but the tailshaft side was a no go.

2 days later and two new U-Joints

In the end I am walking away !!!!

**syborg tt** · #7 10-05-2022, 02:26 PM

Putting the old brake lines back on to see if they leak and I might as well clean them up a little bit.

I have seen this done on a few cars and I like how it looks.