2nd Chance Camaro - Let the Project Begin - Lateral-g Forums

**fleet** · #1 02-02-2023, 09:59 AM

Congrats MJ…sounds great too!

**syborg tt** · #2 02-02-2023, 10:26 AM

It's Sunday Morning and I have one goal and that is to here the car running and running correctly.

Fixed and now I am finally going to start it and hopefully it sounds better.

Time to call Andrew and give him the good news.

**syborg tt** · #3 02-02-2023, 10:29 AM

Quote:

Originally Posted by Cosmo mentis

Congrats MJ…sounds great too!

Thank you Thank you

Quote:

Originally Posted by camcojb

I thought it was because you still had the injector wires over the fuel rails instead of under...

Trust me it's killing me to have them like that.

**camcojb** · #4 02-02-2023, 10:44 AM

Quote:

Originally Posted by syborg tt

Thank you Thank you

Trust me it's killing me to have them like that.

Fix it??

**syborg tt** · #5 02-02-2023, 12:07 PM

Couple more small leaks.

Nothing major just needs to be tightened

Since I missed the PFT tape everywhere else I decided we needed to look at the fitting under the manifold.

Since the intake tube needs to be bead blasted and anodized black it was no big deal removing it.

Nothing to see here as it looks like I remember to do these.

Noah was supervising Mike & I

More reminder notes

At some point I will remove this fitting and put some tape on it.

That's all folks

**WSSix** · #6 02-02-2023, 05:22 PM

Congrats on getting it running!

**syborg tt** · #7 02-03-2023, 02:02 PM

Quote:

Originally Posted by WSSix

Congrats on getting it running!

If it wasn't for Andrew it wouldn't be running that is for sure.

Quote:

Originally Posted by $mike70Z28

A+A+ Marty i did not see any chunky in the pics lol

Thank you and I am stopping at Ace Hardware for some Chunky on my way home.

**Goosesdad** · #8 02-05-2023, 05:30 PM

Nice!

**syborg tt** · #9 02-09-2023, 02:01 PM

So tonight it the night where I am going to move some wires around. I made myself a cheat sheet so I can
visually see the four wires I need to move on the plug. Looking at it like this makes it seem very easy.

**syborg tt** · #10 02-09-2023, 06:13 PM

So, I tried to remove the pins however the heat shrink is so close to the terminal that it is
impossible to pull on gently. The other issue is the black retaining clip is in the way so I quit.

Moving to plan B. I going to have a gentleman out from Florida build me a new Coil harness that
is wired correctly and I am sending these back to Summit Racing since the guys at Wiring Specialties
were not interested in Helping me.

Here is the picture before I move the black clip back and now imagine how tight the space is.

Much better picture for reference