2nd Chance Camaro - Let the Project Begin

[syborg tt]

Next project is the passenger side door panel.

As you can see the holes didn't really line up.



I gentle used the nut driver to push down on the backing to release it from the board so I could install the clips.





I decided to make a "E Flute" cardboard template for drilling holes in the door.









Nailed it !!







Clips installed



Everything lined up perfectly.



Since I have three points of contact (window crank & arm rest screws) I was able to used this for drilling all of the holes in the door.



I cut a small opening for the door handle to see how close I got.





Pictures doesn't show it but i was 3/8 of an inch to high.



Calling it a night





why so many tools ?



This is kinda funny. Where the heck am i going to find one of these two size drill bits.



Cont. in next post