rod/exhaust hanger bender

[WSSix]

Jody, what's the diameter on your exhaust hangers? I'm so far only find 0.47" diameter and the Eastwood bender says it's only good to 0.375". Did it still work well with 0.47" rods? Thanks

[camcojb]

Originally Posted by WSSix

Jody, what's the diameter on your exhaust hangers? I'm so far only find 0.47" diameter and the Eastwood bender says it's only good to 0.375". Did it still work well with 0.47" rods? Thanks

Amazon has several different universal 3/8" hangers.

https://www.amazon.com/Universal-Exh...0BPCXDJGP&th=1

[WSSix]

What about the rubber hangers? All I am finding there is the 12mm holes. I would think these had to match. Do they not? This is my first time trying out these components so I appreciate the guidance. Thank you

[camcojb]

I think mine came with the Magnaflow exhaust. They don't have to be super tight, the inner/outer knobs won't let them slide off.

Here's a place with 3/8 and 1/2" hanger rods and rubber.

https://www.aceraceparts.com/blogs/n...0pack%20of%202.