DREAMIN TA 2

[Panteracer]

Need to clean things up a little... rear suspension is pretty cool
Again front has a bunch of surface rust so working on that
also.... Not sure how these guys can leave things rusting away
on the side yard... underside is mostly grime etc
We will fix it

Bob

[Panteracer]

I just started a little cleanup on the front end
Will hopefully take it outside and hit things with a
wire wheel this weekend

Again a Maier built front end

He braced the front of the frame with an insert
He installed a piece inside the cross member to receive the lower a arm
He installed a triangle to receive the rear lower a arm
Adjustable sway bar with bearings
upper a arm assembly all new with button type adjustments like my race car

Hopefully will get the triangular rear suspension cleaned for pics

Bob

[carbuff]

Thanx for sharing. Does Maier make that upright? And what hub is used? Interesting setup...

[Panteracer]

Not sure about the upright.. going to pick up the glass
front end, some wheels and a trans from the guy I
bought the car from tomorrow

Hub is Howe

Bob

[Panteracer]

Found out Maier made the front hub... one of two- Hobaughs car has the other

A few shots of the rear triangular rear end
Lotus 3 link or Chapman link... like a torque
arm but lower arms go to the frame forward
similar to a torque arm but in a triangle... may
convert to a torque arm later...
Shocks a lot longer like Nascar stuff
Will clean and paint things up little by little

Bob

[Panteracer]

I have been cleaning things up and removed
two of the four door bars. This is only going to be
an autocross car so at 6-2" I want easier access
into the car... Ordering my new Kirkey 65 series
seat and will work on seating fitment along with
rear firewall fab and some bracing at the
rear shocks, etc... Need to look at pedal locations etc
as I may install aftermarket style with new masters

Bob