5 Years Later - It's Not a "new" Project, And Not a New Member Anymore!!! - Lateral-g Forums

**syborg tt** · #1 02-06-2007, 07:50 PM

Guy getting the rings Ready.

Testing them in the Block.

Rods & Pistons ready to install in the block.

The Long Block should be Assembled in the next week or two.

**syborg tt** · #2 02-13-2007, 06:57 AM

Good Morning All,

The truck is in Limbo right now.
I need to buy an enclosed trailer so I've spent all of my spare time looking for one.

In the meantime the Guy's at Rockford Racecraft have assembled the short block.
All the parts getting ready for there new home.

The infamous v6 Billet Crank.
For you v8 guy's these only take 6 to 9 months to get and cost a small fortune.
$3000.00

The Bowtie Block came from GM with ARP Studs.
Saves a little money there but then again the block wasn't cheap either.

The Crank Resting in it's new home.

Wait, I don't have any pics of the pistons in the hole.

black2002ls · #3 02-13-2007, 07:41 AM

lookin' good marty

Nate Hanson · #4 02-16-2007, 06:15 AM

Hi Marty!

**syborg tt** · #5 02-16-2007, 08:18 AM

Quote:

Originally Posted by Nate Hanson

Hi Marty!

welcome aboard

Nate Hanson · #6 02-16-2007, 10:04 AM

Quote:

Originally Posted by syborg tt

welcome aboard

Of course, glad to be here. Now you can introduce me to some guys that will steer in the right direction as far as some modifications and suggestions.

**syborg tt** · #7 02-22-2007, 06:08 PM

Good Morning All,

Meet with the Interior guy last week and we are going to start working on the interior while I am waiting to go to paint.
Plans are to Haul the cab over to them early next week now that I have an Enclosed Trailer.

As promised pictures of the pistons & rods in the short block.

Dan at DLS set us up with the Cam Specs

Comp Cam built the Camshaft for us.

Cloyes Hex-A-Just Timing Chain Set

Cam is in the hole (in my best Bill Murray from Caddy Shack voice)

More cool tools that I can't afford.