JCG Kuwait 1969 Camaro Build - Page 19 - Lateral-g Forums

**Sieg** · #**181** 05-10-2012, 11:49 PM

Quote:

Originally Posted by Gonzo

It will be tough to get it to hook up ..

If it hooks up I hope it has steering brakes!

**syborg tt** · #**182** 06-24-2012, 07:47 AM

Chris I'm bored stuck at home for 2 more weeks

You gotta get me some pics

LowchevyII · #**183** 06-24-2012, 07:59 AM

damn cris, I finally have been getting caught up with some builds on here and am blown away with this one. Looks great! I'll have to stop by sometime soon and check it out!

Cris@JCG · #**184** 06-25-2012, 01:40 PM

Thanks Jeff... Stop on by late next month when th car car is on the ground... I got my SpeedTech Rear Suspenssion today.. Plus the wheels arrived last week...

Quote:

Originally Posted by LowchevyII

damn cris, I finally have been getting caught up with some builds on here and am blown away with this one. Looks great! I'll have to stop by sometime soon and check it out!

**214Chevy** · #**185** 06-25-2012, 03:13 PM

Damn, those wheels looks sick. Can't wait to see them sitting under that beast.

**tones2SS** · #**186** 06-25-2012, 05:37 PM

Quote:

Originally Posted by 214Chevelle

Damn, those wheels looks sick. Can't wait to see them sitting under that beast.

^^You said it Marcus. Those look great!

LowchevyII · #**187** 06-26-2012, 10:58 AM

Quote:

Originally Posted by Gonzo

Thanks Jeff... Stop on by late next month when th car car is on the ground... I got my SpeedTech Rear Suspenssion today.. Plus the wheels arrived last week...

Sounds good! I'll definitely be sure to do that

SLO_Z28 · #**188** 06-26-2012, 04:29 PM

So this car is getting one of those super dooper rear ends too? Those wheels are sexy!

72Z/28 · #**189** 08-07-2012, 02:43 AM

Any update on this beast?

Cris@JCG · #**190** 08-22-2012, 07:59 AM

Here is a small update... We had to go back to the drawing board on the sub-frame rails & re-design them.. but now everything is looking good.. the rack n pinion has clearance for the steering shaft... We have motor mounts for LS engine.. The frame rails were to narrow... so we opened them up one inch per side... & the main reason for a re-design on the frame rails was to optimize the fabrication of the frame rails .. we cut our fab & assembly time down to 50%...