oil breather tank

[70 tt rustang]

Hey all I have I 428 Windsor in my 70 Mustang I've been getting a little bit of oil out of the breathers. I don't want a mess on my motor or under the hood. So I am thinking about doing a breather oil tank. I wanted to know what tanks you all recommend what size line and where I should weld my fittings on my valve covers. Thanks for the help

[70 tt rustang]

Anyone have any suggestions?

[ADY]

I installed a Moroso air-oil separator connected to a pvc-valve on one side (breather on the other) and ran it in to the intake manifold. Stopped oil coming out of the breather and collects all the nasty blow-by.

http://www.shopmoroso.com/eb/catalog...nuId=main.menu

[Che70velle]

Check out page 26, post numbers 254 and 255 in my build thread, link is in my signature. The tank is made by Allstar, and I believe I bought it at Summit. Came with bracket and filter. The line size is -10.

[70 tt rustang]

Originally Posted by Che70velle

Check out page 26, post numbers 254 and 255 in my build thread, link is in my signature. The tank is made by Allstar, and I believe I bought it at Summit. Came with bracket and filter. The line size is -10.

So did you do 2 tanks or is there a crossover? It looks good what size line did you use?

[Che70velle]

Originally Posted by 70 tt rustang

So did you do 2 tanks or is there a crossover? It looks good what size line did you use?

1 tank off of passenger side valve cover. No crossover, and line size is a -10, which is almost 5/8" ID.