Brake Line Routing, Ford 9"

[ZZ3ElCamino]

I am starting to start the layout for my rear brake lines across my 9" rear end, and I am not sure how I want to run it. Does anyone have any pictures of how they ran their brake lines across their rear diff? It would be helpful if some could post some pics. Thanks

[quadfather]

if your worried about the way they look . you could run 2 braided flex hoses up. 1 from each wheel and then tee them together. i like it that way so when you doing maintenance , or if you have to remove the rear you can just hang the calipers, and not have to bleed the brakes after.

[ZZ3ElCamino]

Good call! I didn't even think about that.

[Payton King]

used braided line on each side of the tee out to the calipers. I zip tied them to the axle housing in a couple of spots. Vaccum line was used where the tie held it to the housing to keep the braided stuff from cutting the tie or rubbing the finish off the housing.

[ZZ3ElCamino]

I want to have hard line because I don't want to hose clamp or zip tie anything around the housing. To me I think that method looks kinda half a$$ed. If I am running line I might as well take my time and do it right.

[Payton King]

already welded to the rear end housing you are going to have to zip tie or mount them (hard lines) in some form or fashion anyway. If your rear end housing is not painted or coated you can weld on tabs and use either hard line or the braided stuff.

The main reason I went with braided is it makes it very easy to service the brake system. I do not have to disconect the lines if I need to remove the caliper to change rotors or have them turned. I am running the wilwood calipers, so I do not need to remove them to change pads. Depending on what caliper you are using you may need to.

Just a thought