2nd Chance Camaro - Let the Project Begin - Page 27 - Lateral-g Forums

**syborg tt** · #1 08-30-2018, 10:19 AM

Moving on to the header removal. Okay let’s just say this design worked perfectly as it was a 20 minute job to remove them.

When they go back in there will be ARP Header Studs going back in.

Just a quick shot of the Powder Coated rear end. Need to take inventory of all the hardware and order the new ARP 6 point stainless bolts and new EBC rotors in black.

**syborg tt** · #2 08-30-2018, 10:20 AM

Almost forgot that I worked on three fat bikes and did a carbon bar swap on Mikes 27.5 mid-fat bike.

These three posts where from July 15th

**syborg tt** · #3 09-07-2018, 08:25 PM

So the header are back from getting coated and the down tubes are wrapped in DEI Ti Thermal wrap. I also added studs to make it even easier to install the headers which takes all of 10 minutes for both sides.

Sent from my iPhone using Tapatalk

**syborg tt** · #4 12-09-2018, 07:28 PM

Need to shorten the exhaust by 1/4'' and also plan to to wrap the mufflers with the DEI Muffler Shield.

Mike's pretty darn good making a straight cut with a Sawzall

small learning curve here for both of us.

**syborg tt** · #5 12-09-2018, 07:51 PM

Next Up put some DEI wrap on the tailpipes

This bike stand is really getting a workout.

**syborg tt** · #6 12-09-2018, 08:16 PM

New Totally Stainless Sway Bar Links

The original set was a little short so we had to send them back.

Before

After

**syborg tt** · #7 12-09-2018, 08:37 PM

Still updating the factory hardware to ARP or hardware from the guys at Totally Stainless.

Of course the inner fender is in the way. However since they are fiberglass/Carbon that is easily solved.

**fleetus macmullitz** · #8 12-09-2018, 09:09 PM

Enjoying seeing this one fleshed out MJ.

**syborg tt** · #9 09-07-2018, 08:28 PM

While I was working on the car I decided I needed to make a down and dirty hood prop as my hood kept falling on me.

Thank goodness for PVC pipe and a dremel.

I wrapped it in red electrical tape so I would remember to remove it. Plus it adds a little friction as it snaps over the shock rod nicely now.

Sent from my iPhone using Tapatalk

MtotheIKEo · #10 09-07-2018, 08:50 PM

Are the hood struts worn out or did they never work great to begin with?