LS3 Headers?? - Lateral-g Forums

sginphx · #1 10-05-2015, 06:56 PM

Building a stroked LS3 with a 4L80E tranny for my 67 Camaro. Anyone have any input on which headers to run?? Sure could use the help! Thanks

Musclerodz · #2 10-05-2015, 07:10 PM

ultimate headers. Will clear just about any setup.

ADiCarlo · #3 10-05-2015, 11:40 PM

Mike do you have any pictures of them installed on a DSE subframe? Trying to see how close they get to the body when they go under the car.

Sent from my iPhone using Tapatalk

Yelcamino · #4 10-06-2015, 08:50 AM

I just found this company the other day...

American Racing Headers

I'm looking at a set for my El Camino LS swap.

Musclerodz · #5 10-06-2015, 09:35 AM

Quote:

Originally Posted by ADiCarlo

Mike do you have any pictures of them installed on a DSE subframe? Trying to see how close they get to the body when they go under the car.

Sent from my iPhone using Tapatalk

https://lateral-g.net/forums/show...timate+headers

sebtarta · #6 10-06-2015, 11:38 AM

Holley-Hooker has the LS swap, engine mounts trans crossmember and headers which fits and aligns everything perfectly.
Headers go in line with the frame, huge ground clearance.

XLexusTech · #7 10-06-2015, 06:43 PM

Stainless works bought from a member here who sells them...

http://www.palmettoperformance.com/

Superlite Coupe · #8 10-11-2015, 12:48 PM

If you're limited on space ... I used a set of LS7 stock hydro-formed take-offs on my LS376. They hug the block, GM spent tons of money developing them and brand new take-offs cost me 200.00 a pair shipped. Just a thought.

jeremy30thz · #9 10-11-2015, 07:29 PM

Quote:

Originally Posted by XLexusTech

Stainless works bought from a member here who sells them...

http://www.palmettoperformance.com/

Thanks man!

Quote:

Originally Posted by sginphx

Building a stroked LS3 with a 4L80E tranny for my 67 Camaro. Anyone have any input on which headers to run?? Sure could use the help! Thanks

What subframe are you using?

**waynieZ** · #10 10-11-2015, 10:48 PM

I just put the 1-7/8" ARH headers in my 69 with the S&P swap plates fit great with my LSA/4l85 you would just need them to put the 02 sensors on the outside of the collectors. They tuck up nice and tight. Pictures in my build thread. The trans tunnel needs to be clearanced on the drivers side because its so wide.