Mustang drop spindles

[Flash68]

Mike for suspension....

Charles for fiberglass....

Next!

[DBasher]

Originally Posted by chetly

They didn't respond then and i doubt they'll respond now. Glad I don't have their spindle on my car...

Yeah, not real big on communication.....or testing, engineering and apparently metal fab.

[DBasher]

Originally Posted by Flash68

Mike for suspension....

Charles for fiberglass....

Next!

Party pooper! Don't you have data to share that shows how unfast you were?

I shared for a few reasons. The number 2 reason is because, its my opinion, that the new suspension products being put out of this shop dont have anything solid to back them up.....other than they work on the display model in the show room.

[Sieg]

Originally Posted by DBasher

Party pooper! Don't you have data to share that shows how unfast you were?

He's blisteringly fast, just put a beer in his hand and ask him.

[craig510]

Thanks for the picture Dan. Hopefully this will keep someone from getting hurt. We have been talking about how dangerous they looked from the first time I saw them.

Nothing quite like a heat affected zone in flat sheet metal under ~7500 ft-lbs.

[Flash68]

Originally Posted by DBasher

I shared for a few reasons. The number 2 reason is because, its my opinion, that the new suspension products being put out of this shop dont have anything solid to back them up.....other than they work on the display model in the show room.

I didn't even know Charles was still putting out suspension parts...

[chetly]

He is, but obviously his quality control leaves a little to be desired...

[DBasher]

Originally Posted by Flash68

I didn't even know Charles was still putting out suspension parts...

You've got a lot to learn in the mustang world...🦊