Mounts for LSA in first gen Camaro

[billohio]

I am getting some parts around to put a LSA in a first gen camaro. I have read the post where my stock frame will need to be notched for the a.c. compressor. I wondered if anyone here that has done this swap, what did you use for motor mounts? Do the Holley mounts move the engine back into the crossmember more? Are there any lower compressor mounts that help with the frame notch? I will be adding vintage air and they sell a bracket but didnt know if that was the one I need.
I will be using a TR6060 transmission and sounds like I need to make my own transmission crossmember.
Thanks in advance and I appreciate all the posts with good info here!

Bill

[jimmythehand]

try lsx concepts, or concept one. can't remember which one i went with, but did LSA swap with speed tech subframe and did not have to notch frame.

[ZMAN1969]

Bill, you will need to swap oil pan and remove oil cooler from LSA motor they hold 8 quarts of oil and wont fit the frame as sump is too long - if you didn't already know this

[GEARBOXGARAGE]

Here's the A/C bracket that Speedtech suggested for running an LSA in their ExtReme subframes. The place is called Kwik Performance and they have a mini LSA A/C mount specific for LSA swaps into vintage vehicles or low clearance swaps.

http://www.kwikperf.com/lsx_high_mount.html

[billohio]

Thanks guys. I am getting about ready for a test fit and wondered what to do with the oil cooler too. Did anyone use something to replace the oil cooler??

[joeko23]

There are oil coolers like this, but they don’t use coolant like the stock unit not sure if that makes any difference. All my research in the subject pointed to that most people just delete the oil cooler.

https://www.amazon.com/Aluminum-Engi...97757500&psc=1