Big Ford End - "Bolt-On" C6/7 Hybrid Floater - Page 7 - Lateral-g Forums

Sonar Chief · #61 02-14-2020, 06:33 PM

Quote:

Originally Posted by 214Chevelle

I hope not. Currie built the rear end and I sent them the Miller Built kit as Jay said they've installed many of his kits. Can anyone else verify how this looks? Even if it is upside down, I still have to install the 3rd member, axles, etc. Plus, everything else is coming back off to get the chassis and rear end powder coated.

I can verify that the pic from Currie is correct for OEM installs. I did change mine from OEM install to get the brake caliper in front (lower CG when applying the brakes) and also keep the brake pull coming in from the front.

I swapped out brake sides basically and keep the pull lever on the top ... check out the pics here from my thread:

https://lateral-g.net/forums/showthr...34830&page=134

**MillerBuilt** · #62 02-14-2020, 09:12 PM

You really cannot mount them wrong per say. This kit is VERY versatile and can be properly installed more than one way.
Calipers can be mounted rear/front of the wheel, as well as the e-brake cable approach above/below axle tube and all depending on what side/direction the MillerBuilt adaptor is mounted.

Sonar Chief took it a step further and has the caliper and e-brake cable approach on the same side.

All just depends on what works best for each particular application and possible variables.