70 Camaro - Boise, Idaho - Page 12 - Lateral-g Forums

**Goosesdad** · #**111** 05-02-2017, 10:42 AM

Quote:

Originally Posted by Jimbo1367

GReat update. Hard to believe you did the beadwork with the HF modified BR. And closer pics showing the bear roller? WHat whinch did you use? I bet others would like to see this and copy. Great idea. Never seen one powered like that before.

Posted my backyard bead roller pics here, though I'm a little embarrassed....it works but...!!!

https://lateral-g.net/forums/show...d=1#post658249

Jimbo1367 · #**112** 05-03-2017, 01:57 AM

Pretty cleaver !!!

thanks,
JIm

**Goosesdad** · #**113** 05-21-2017, 11:38 PM

Still a work in progress but did manage to tighten up the deck lid gap.

**Goosesdad** · #**114** 06-11-2017, 09:00 PM

Rear bumper body work is in progress. I think it might be a little too "angular", think I might have lost some of the softness of the factory bumper shape. Once I get the other side done, I'll decide if I should redo the transitions and make them softer.

**Spiffav8** · #**115** 06-11-2017, 09:45 PM

I see what you're saying. I admire the work and more so that you're wiling to do it twice to get exactly what you want.

**WSSix** · #**116** 06-13-2017, 10:42 PM

Top notch work as always, but I agree, I think it's too angular. Good luck!

**Goosesdad** · #**117** 06-14-2017, 12:14 AM

Quote:

Originally Posted by Spiffav8

I see what you're saying. I admire the work and more so that you're wiling to do it twice to get exactly what you want.

Quote:

Originally Posted by WSSix

Top notch work as always, but I agree, I think it's too angular. Good luck!

Appreciate the feedback. Started the correction. Should be done this weekend. I don't know WTF I was thinking. Had the rendering hanging on the wall, 3' away from where I was working and I still went down that angular path. The whole point of this was to keep the factory lines.....brain fart I guess.

**Goosesdad** · #**118** 06-18-2017, 09:56 PM

Still have the lower section on the passenger side to complete but I did get it much closer to the factory shape. Still laughing at myself with that first effort.

Will tackle the outer areas next weekend.

**Spiffav8** · #**119** 06-18-2017, 11:12 PM

Quote:

Originally Posted by Goosesdad

I don't know WTF I was thinking. Had the rendering hanging on the wall, 3' away from where I was working and I still went down that angular path.

That right there explained to me why I see cars being worked on with a copy of the rendering tapped to the part they are working. Total light bulb moment.

**Goosesdad** · #**120** 07-06-2017, 12:08 AM

Made some more progress on the rear bumper. Ended up rebuilding the sides again, just trying to get the shape right and symmetrical. Templates and a laser have it pretty darn close! I'm in the middle of the lower radius'd part. Made a wood jig to shape the lower corner. I will finish it all by the weekend.