Roadster Shop 2nd Gen Camaro Build

[GregWeld]

Originally Posted by Roadster Shop

When you start lowering your consulting fees maybe we will start using you!

Either way it is a few bolts and the fan comes right out.

Good one!!



It was hard to tell the clearance from the anti-roll bar...



That build is fantastic BTW!!

[coolwelder62]

[broken1234]

Very cool... keep 'em coming...

[syborg tt]

Originally Posted by Roadster Shop

We will throw a few more pics up tomorrow. Been doing a lot of the little detail work in the engine compartment, fabbing the exhaust, and finishing up all of the loose ends before going to body work.

Well it's today and I'm bored !!!!

[RS-Chris]

Some progress update pics:

Received our custom ordered gauge set from Speedhut (with 200MPH speedo of course, boost gauge not pictured)



Work continues on the motor plumbing, intake etc. Mock up of the revised intake for the Nelson plenum: The intake will span from ahead of the radiator core, rearward to the regular intake opening. The roughed out profile pieces you see will be machined from aluminum with a rubber bellow connection the same profile as the ends you see here.











On the underside, fab work begins on an air scoop to maximize airflow.







Underside shot:

[Vince@Meanstreets]

Im liking the new intake run for the Nelson intake...can't wait to see the steps to make it happen.

[Al Moreno]

nough said

[protour73]

.....ummmmm........WOW

Originally Posted by RS-Chris

On the underside, fab work begins on an air scoop to maximize airflow.

[coolwelder62]

WOW!!!!! That's just about as COOL as it GET!!!!!!!!.

[Rick D]

Very nice as aways! Like Scott said WOW!