This car was originally a column-shift automatic with a bench, and eventually switched to a floor-mount shifter with a console. So we cut the stub off of the column, filled & painted the area.
The column on these have a 1" 48-spline shaft
When the stock column is used on our chassis, with an LS engine & our stainless headers, 3 joints are needed in the steering shaft. An aftermarket (Flaming River/IDIDIT) column that is a little shorter can typically use a 2-joint shaft. To support the shaft, we used a 3/4" heim joint on a custom bar mount. To keep it from pivoting around the tube, a hole was drilled & tapped into the tubing & bolt inserted.
Black anodized billet serpentine system installed: w/Sanden AC compressor, 140a alternator, power steering, ATI dampener.