1969 Camaro Restomod Project Thread

[rickpaw]

wheels look great Will. have to stop by GAP to check out the car. I work only 10 min from GAP.

[will69camaro]

Originally Posted by rickpaw

wheels look great Will. have to stop by GAP to check out the car. I work only 10 min from GAP.

Me too! I work at WestChase so very close. Going to try and go by tomorrow. But day tomorrow. Ordering engine, trans, fuel system, etc. wheels to be ordered this week also!!!

[Spiffav8]

Looking good buddy!!

[rickpaw]

Originally Posted by will69camaro

Me too! I work at WestChase so very close. Going to try and go by tomorrow. But day tomorrow. Ordering engine, trans, fuel system, etc. wheels to be ordered this week also!!!

When are you planning to stop by? Maybe we can hook up. I typically get off from work around 2:30 pm.

[will69camaro]

Originally Posted by rickpaw

When are you planning to stop by? Maybe we can hook up. I typically get off from work around 2:30 pm.

Depending on Tim's availability, I may try to be there around 4:30 today.

I'm there most Fridays now. Not sure if I'm going to make this Friday as I have plans to go to Texas Invitational in Dallas.

William

[Twinstang]

Originally Posted by will69camaro

1000+ rwhp

Very nice what kind of engine management you using.

[will69camaro]

Planning to use the Holley Dominator ECU.

[tones2SS]

Looking good Will.
Nice to work so close to the shop, to just stop by every once in a while and see things in person.

[will69camaro]

Tim can attest, i'm there all the time. I'm determined to spin some wrenches on this thing. GAP is letting me do so, so I've found a perfect partner for this project.

We got some parts on order today (big parts) and measured for the rear wheels for the tire I want to run. I'm excited!

William

[will69camaro]

Test fitting the 345/35/18 MT DR.

Looks like 18x12 w/ 6.25" BS is the ticket.







William