Anyone run Stainless Works headers on Art Morrison subframe?

[Bowtieracing]

Originally Posted by ProdigyCustoms

No worries, The radiators (I have 3 being done) are being built, and she cannot invoice you untill we get the shipping cost. Since it is a favor deal she does not want to miss on total cost. It will be a couple more weeks before they are ready.

Frank is there one for me too and tank ??

[ProdigyCustoms]

Yours is one of the 3 Joni.

[Bowtieracing]

Originally Posted by ProdigyCustoms

Yours is one of the 3 Joni.

and Frank !!!

[Silver69Camaro]

Originally Posted by dhutton

This must be the butthead engineer coming out in me. My AME headers clear the rear control arm mount on the right side by 1/8". On one hand it's hard for me to imagine that someone else's headers would do better but on the other hand I cannot understand why AME cut this so close - there appears to be plenty of room for them to make the clearance wider.

Don

Basically the problem ended up being able to install the header when the engine is installed. It's not easy, but it can be done - but making more clearance between the header tube and control arm only made the problem worse. Fortunately, with the ceramic coating, heat is not an issue.

Also, we haven't had our ceramic coating fade to the best of my knowledge. Both the Morrisons and I have logged several thousand miles with our headers with no issue as of yet.