The coils are pretty strong, I would think that as long as they are not getting soaked with water they will be fine. You can always put some silicone around all the connections if need be.
the metripack connectors are sealed, and the coil/plug wires are packed with dielectric grease, so I'm not going to worry about it. Worst case, I get towed into the next stop by the Red Witch.................
I do not normally post very often over here, I am more of a lurker. Every time I come over and check out the site I stop by and read over this build. All I can say is that this is an incredible build! The engine bay is absolutely gorgeous, the body is incredible and the fabrication is too cool! Great job on the build and keep it up! I cannot wait for this thing to hit the road!
I do not normally post very often over here, I am more of a lurker. Every time I come over and check out the site I stop by and read over this build. All I can say is that this is an incredible build! The engine bay is absolutely gorgeous, the body is incredible and the fabrication is too cool! Great job on the build and keep it up! I cannot wait for this thing to hit the road!
ok, drivers side done also. Now extend the passenger side harness, wrap the downpipes for plug wire protection, cut and install the wires, turn the key...............
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
......detailed and very functional.
It's like a ball of yarn unwinding, that has no end... Author DKz Garage
Linear Mode
