69' Camaro project at Holohan's Hot Rod Shop - Page 6 - Lateral-g Forums

**GregWeld** · #51 12-25-2011, 02:00 PM

Quote:

Originally Posted by HOLOHAN

Good question about the stock wiring harness location.

I did suggest to eliminate it, but the customer wanted to leave it there....

But, with the big NRE polished BB stuck in there, the focus does kind of go away from it.

But going to make a subtle cover for it as part of the finish detail fab part of the project.

I knew you had a plan.

I just redid my brother in laws '69 firewall -- and put the American Autowire Highway 22 kit in the trunk.... back with the stereo amp etc. MY SISTER couldn't stand looking at that wire connector! So I fixedededed it.

I built a rack that tilts forward -- so he can service the battery (made it so you can just drag the battery over the rack... This area is fully blocked off with an carpeted "board" so you don't see any of this when it's all put back together.

I used their "trunk mount extension kit" to get all the wiring back forward....

coolwelder62 · #52 12-25-2011, 03:33 PM

Quote:

Originally Posted by GregWeld

I knew you had a plan.

I just redid my brother in laws '69 firewall -- and put the American Autowire Highway 22 kit in the trunk.... back with the stereo amp etc. MY SISTER couldn't stand looking at that wire connector! So I fixedededed it.

I built a rack that tilts forward -- so he can service the battery (made it so you can just drag the battery over the rack... This area is fully blocked off with an carpeted "board" so you don't see any of this when it's all put back together.

I used their "trunk mount extension kit" to get all the wiring back forward....

Greg,That's some outstanding work there Buddy.

**HOLOHAN'S HOT ROD SHOP** · #53 12-25-2011, 09:13 PM

Here's the NRE BB in place.
The March front drive was removed, sent back and replaced with a Billet Specialties TruTrac.

mexMan · #54 12-25-2011, 11:43 PM

I like how it's going, and I REALLY like how the engine looks in there.

**HOLOHAN'S HOT ROD SHOP** · #55 12-26-2011, 07:08 AM

**HOLOHAN'S HOT ROD SHOP** · #56 12-26-2011, 07:15 AM

Boss 5.0 · #57 12-26-2011, 09:15 AM

That looks really nice.....I LOVE your work!

coolwelder62 · #58 12-26-2011, 09:52 AM

Outstanding Work.

**waynieZ** · #59 12-26-2011, 11:14 AM

Awesome work Dan I love the way it came out. I'm looking forward to seeing the cover for the fuse block.

DETON8R · #60 12-26-2011, 12:54 PM

Man, if I had a check book that big, I'd love to stuff anything that has Nelson Racing on the valve covers between my fenders.

Outstanding sheet metal fabrication. Truly incredible.

That kind of work raises the bar another notch.