1965 falcon

[Bryce]

Dan,

I will post up some math a little later.

[Bryce]

Well, I made it out sunday for another successful autocross.

3 guys from the PT world made it out there. Jay Bittle from JBA brought out two mustangs. It was a good turn out on sunday. My upgrades were better. The trans stayed cool and being able to monitor the engine oil temp was nice. The stiffer springs helped on the longer sweepers by reducing body roll. I think a bigger sway bar is next. The falken tires were not good cold. That is my only complaint.

Saturday had some crazy dips and a few cars did not survive. I am glad I didnt make it out on saturday.

I will post some videos tonight. I got 7 runs.

[Bryce]

Time for pictures:



because RaceCar! yep, thats my SCCA number.



All empty and clean... time for a change.



and my new office:

[waynieZ]

Nice set up on those replacements for the tie rod ends, and a well stocked office..

[Flash68]

Bryce, love the garage setup. Simple, effective, and has the requisite stuff.

[Bryce]

Originally Posted by waynieZ

Nice set up on those replacements for the tie rod ends, and a well stocked office..

Originally Posted by Flash68

Bryce, love the garage setup. Simple, effective, and has the requisite stuff.

Thanks guys.



Here are the results from the last SCCA event: http://www.sdr-scca.com/solo2/result...-2_fin-web.htm

Here are some links to the pictures:

http://lateapexphoto.com/p783852798/h57a45474#h57a45474
http://lateapexphoto.com/p783852798/h57a43cc4#h57a43cc4
http://lateapexphoto.com/p783852798/h57a44c54#h57a44c54
http://lateapexphoto.com/p783852798/h57a446dc#h57a446dc

I need a bigger sway bar to reduce body roll. I think there is some daylight on the inside tire acclerating out of a turn.

[Bryce]

Found out I have some slop in my low friction ball joints. Too much slop for me, time for upgrades. I will be going to a sperical bering instead and have some roll center and camber gain adjustments. But this change will put out for GG del mar.

[Bryce]

A couple more pics as I slowly put the sway bar in:

[Bryce]

a few more progress pics:

Sway bar mounts and new ball joints.

[coolwelder62]

Very cool.