T56 LS1 Bellhousing - Lateral-g Forums

**Swain** · #1 07-21-2014, 11:59 AM

Question my bell housing only had a hole for my hydraulic clutch line. No hole to get to the bleeder nut. Any ideas on what to do to bleed the clutch? Do I need to make a hole in the Bellhousing to get to it?

Vince@Meanstreets · #2 07-21-2014, 02:30 PM

Quote:

Originally Posted by Swain

Question my bell housing only had a hole for my hydraulic clutch line. No hole to get to the bleeder nut. Any ideas on what to do to bleed the clutch? Do I need to make a hole in the Bellhousing to get to it?

what bell do you have? should have a slot cut out for it.

**Swain** · #3 07-21-2014, 02:53 PM

Pretty sure I got it from thegearbox.org. Its been a couple years.

Vince@Meanstreets · #4 07-21-2014, 03:10 PM

Quote:

Originally Posted by Swain

Pretty sure I got it from thegearbox.org. Its been a couple years.

is it a stock f body type or an SFI bell?

**Swain** · #5 07-21-2014, 03:18 PM

looks like a stock F Body style. Its cast aluminum.

Vince@Meanstreets · #6 07-21-2014, 03:28 PM

should have a slot like

**Swain** · #7 07-21-2014, 03:33 PM

Thanks for the help. I will take some pictures tonight.

**Swain** · #8 07-21-2014, 09:48 PM

Quote:

Originally Posted by Vince@MSperfab

should have a slot like

I found the hole haha

Vince@Meanstreets · #9 07-22-2014, 03:15 PM

ain't going there, haaaa

OBeer-WAN-Kenobi · #10 07-22-2014, 04:25 PM

Quote:

Originally Posted by Vince@MSperfab

ain't going there, haaaa

I was thinking the same thing. But if you found the hole when you were looking for the slot, I'm not sure that can be fixed.