...

Go Back   Lateral-g Forums > Technical Discussions > LSX Conversions
User Name
Password



Reply
 
Thread Tools Display Modes
  #1  
Old 08-10-2021, 06:44 PM
XLexusTech XLexusTech is offline
Senior Member
 
Join Date: Jun 2007
Posts: 1,331
Thanks: 85
Thanked 109 Times in 63 Posts
Default Tach issue

HI I have an LS3 PSI harness and an auto-meter electronic tach. The tach is a special addition 2006 Gm Performance parts issue that I need to keep.
I mention this because tachs pre 2007 are known to have a problem with low voltage signals.

Tach is inoperative but is fine on a bench test. Found lots of info about using a step up resistor inline. Then found so much conflicting info.. Mus use 12v.. not must use 5V... must use 1Kohm.. no us 5K ohm. that I got really worried.

So I went out and bought autometer 5117 https://www.autometer.com/tach-adapt...E&gclsrc=aw.ds

question has used this tach adapter? Instructions say tap into each coil bank.. which I am not doing..
I want to use the tach signal (white wire) out of PSI harness

Alternatively If someone could set me straight on the step up resistor that would be helpful as well
Reply With Quote
  #2  
Old 08-11-2021, 08:33 AM
protour's Avatar
protour protour is offline
Member
 
Join Date: Sep 2005
Posts: 83
Thanks: 3
Thanked 19 Times in 14 Posts
Default

Quote:
Originally Posted by XLexusTech View Post
HI I have an LS3 PSI harness and an auto-meter electronic tach. The tach is a special addition 2006 Gm Performance parts issue that I need to keep.
I mention this because tachs pre 2007 are known to have a problem with low voltage signals.

Tach is inoperative but is fine on a bench test. Found lots of info about using a step up resistor inline. Then found so much conflicting info.. Mus use 12v.. not must use 5V... must use 1Kohm.. no us 5K ohm. that I got really worried.

So I went out and bought autometer 5117 https://www.autometer.com/tach-adapt...E&gclsrc=aw.ds

question has used this tach adapter? Instructions say tap into each coil bank.. which I am not doing..
I want to use the tach signal (white wire) out of PSI harness

Alternatively If someone could set me straight on the step up resistor that would be helpful as well
12v 1kohm resistor. Follow this. https://lt1swap.com/lsx_tach.htm Ive done it several times.

Also make sure that the tach is set for 4 cylinder.
__________________
72 Chevelle. 370ci LS, Forced inductions S476, SpeedTech Suspension equipped, C6 Z06 brakes
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:14 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright Lateral-g.net