Wilwood MC pushrod on 65 mustang ???'s
Hey all, so I have completely converted my 65 mustang to wilwood brakes front and rear and I also got their master cylinder. I got one with a 1 inch bore and I got an adjustable pushrod kit with the eyelet and all......except for the rod that threads into the adjustment sleeve and pushes on the MC's plunger! Am I just suppose to make one? Has anyone else had to go through this problem and how'd you make it work? I was hoping that the dang kit would have just come with the pushrod. Anyways any advise would be helpful! Thank you!
Nik
__________________
1965 Mustang Fastback- 289/T5, longtubes, 3 in. exhaust, flowmaster super 10's w/ sidepipes, centerforce clutch, Wilwood 6 front, wildwood 4 rear, wildwood MC, 70 mustang spindles, Shelby drop, Shelby quick steer, C&R third member, 3.50:1 gears, Detroit locker, Moser 31 spline axles, Mike Maier panhard bar, 165 race leaf springs, harness/roll bar, and adjustable rear sway bar
|
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Linear Mode
