I picked up this old Edelbrock X-C8 crossram and i'm looking for advice on carbs. Holley recommends the 450 tunnel ram carbs but others have said to go with the 600's. Any of y'all ever set one up and get it tuned good?
It's going on a mild SBC 383 stroker, 401hp @ 5200 rpm 437tq @ 4200 rpm 5500 rpm rev limiter
The Following User Says Thank You to 68454RS For This Useful Post:
The manifolds look cool, but were not the best performing setups. Seemed to work good at WOT. I would be thinking a pair of 390's or 450's max on a mild small block that's a street car.
The manifolds look cool, but were not the best performing setups. Seemed to work good at WOT. I would be thinking a pair of 390's or 450's max on a mild small block that's a street car.
Yeah, That's about all i've heard is that these are not good for performance. I am going for the cool factor but still need to be driveable.
The Following User Says Thank You to 68454RS For This Useful Post:
I set it up with a pair of QFT 450's. Had the vac advance and pcv hooked up from both carbs to a "T" then to the dist and pcv... it didn't like it. I removed all the vacuum stuff, removed the vacuum advance from the dist, locked out the mechanical advance, set the timing at 32 degrees, and now she seems to be happy and snappy.
Still need to build some stainless braid fuel lines
I built a manometer based on a video from Unity MotorSports Garage you tube channel. I'm going to see if I can get these balanced with my home made carb tool.
The Following User Says Thank You to 68454RS For This Useful Post:
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Cross Ram tuning, where to start?
Linear Mode
