Anybody ran into this before? After detailing the original e-brake Assy I managed to sheer a mounting stud off during reinstallation. Do these studs press in? Looks as though they are captured somehow similar to a carriage bolt etc? Any info on a good replacement here aside from replacing the whole assembly?
You can cut it out and tac weld a 3/8" bolts back in.
Appreciate the info. By cut do you mean drill out? Was hoping there would be other alternatives rather than the welding in a bolt method, but that may have to do
Appreciate the info. By cut do you mean drill out? Was hoping there would be other alternatives rather than the welding in a bolt method, but that may have to do
There are alternatives......but why? Grind a flat on stud with a die grinder, center punch it, then drill it out. You could use a flat head bolt but technically it's weaker and more expensive than a grade 5 or 8.
Appreciate the info. By cut do you mean drill out? Was hoping there would be other alternatives rather than the welding in a bolt method, but that may have to do
you could always put it in a box and ship it to me and I could fix it for you.
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
E-Brake Assembly Mounting Studs
Linear Mode
