Budnik Billet Wheels 18" Chevy

[Bow Tie 67]

2 Budnik Teardrop X series 18" x 10" ( 5.5" backspace ) with BFG KDW2 275/35 x 18" tires.
2 Budnik Teardrop X series 18" x 12" ( 5.5" backspace ) with BFG KDW2 335/30 x 18" tires.

These have 3,000 miles on them.

They can be fully polished ( like the first pic ), the pics with the center blacked out are current, this was a quick clean and spray paint no scuffing of rim was performed.

The rear tires have damage on the inside corners ( tread to sidewall area ) this does not effect street or on-track performance. see 2nd pic

These are not perfect, but clean up nice. One rear rim has a ding on the fat lip, I will try and get a pic of it. I was thinking of brushing the outer barrels and believe that would almost make it disappear.

Sold

[Tiger]

Matt,
can you please give me the overall with of the rims and the tires so I can measure fitment on my Chevelle.

thanks!

[Bow Tie 67]

The section widths are 11 1/8" overall on the 18 x 10 rim 275mm tire

and 13 5/16" overall on the 18 x 12 rim 335 mm tire

[Tiger]

Matt,
I left you a PM as well, I just came up from the garage and the wheels wont fit my car.
I'm sorry both for me and you!

[fireboy68]

Just seeing if the wheels are still available. I see you have a 9 inch in your camaro? what is the overall length of your rear end wheel mount surface to wheel mount surface? I getting ready to buy a housing and im thinking i can buy one to match the wheels. Im having trouble figuring out how to do this. I put DSE mini tubs in and want to run a 335 tire. Im running a Chris Alston G-link suspention. Sorry if im being a pain, im trying to figure this all out on my own

If you want my email is [email protected].

Thanks Jeremy

[Bow Tie 67]

Still available

[G's Chop Shop]

will the front wheels fit the stock suspension on a 68 camaro without rubbing? Very interested!!!!!

[Bow Tie 67]

The best thing I can tell you is take measurements. The rims / tires have an 11" section width with a zero offset. So the rim mounts exactly in the center of the assembly. Since they are 18" rims there should be no rubbing on suspension components. You will most likely loose some turning radius, which only effects parking situations. Small mods to the inner wheel wells will most likely be needed. This can be accomplished rather easy with a cheap rivet gun and a flush rivet anvil. If you have any questions PM me.

http://www.harborfreight.com/super-d...els-47868.html

[Bow Tie 67]

Still available

[sperger1]

Sent PM Matt.

Zach