Machined Stainless Steel hardware from Ring Brothers - Lateral-g Forums

**XcYZ** · #1 02-03-2008, 08:16 PM

When I saw these on the shelf at Ring Brothers, I had to have a few for my car. It's these little details that make all the difference. I picked up just enough to replace the fasteners that you could see under the hood.

**camcojb** · #2 02-03-2008, 08:37 PM

yep, I'll be calling Mike for a set for Mali2ude, those are very trick.

Jody

mazspeed · #3 02-03-2008, 08:48 PM

They finally have those out now??? How much for the camaro, and are they car specific?

**XcYZ** · #4 02-03-2008, 09:01 PM

Yep, they're available now. They had a big assortment. You can order as many of any size that you'd like. I just got a few in 5/16" and 3/8". Not sure about a kit, but that would be a very good question to ask them when you call.

mazspeed · #5 02-03-2008, 09:04 PM

That's awesome Scott, thanks for the info. Ill spend my lunch money on them.

eville · #6 02-03-2008, 09:06 PM

Woah, I need some of those. Any werd on pricing?

Blown353 · #7 02-03-2008, 09:38 PM

Hmmmm... I wonder if I could convince my CNC lathe guy at work that I need about 400 of those for "tooling."

James OLC · #8 02-03-2008, 10:12 PM

When i talked to them about what we needed for the OLC project they didn't have a kit but did have 1/4", 5/16", 3/8" and i think a metric size or two. They are absolutely increadible pieces.

**XcYZ** · #9 02-04-2008, 07:24 AM

I should note that they are transitioning to a new website and their e-mail isn't working just yet. Just give them a call at 608-588-7399.

**Steve1968LS2** · #10 02-04-2008, 07:51 AM

That's a lot like what I use except the washers are "deeper". Very nice. What do the back sides look like?

The perfect design would have a small raised disc on the back to help paint deformation remain unseen. Mine are flat on the back.

Also, what is the rough cost per a washer?

They sure make sweet stuff.