I remember reading that someone made an adapter or maybe a new hose to be used when using the factory hydraulic clutch master with an aftermarket hydraulic throwout bearing such as a McLeod unit. I think that it replaced the quick connect with and AN fitting. Does anyone remember this? Or know where to get something that will work?
I was planning to use a T5 bellhousing with the attached slave so I cut the quick connect and silver welded an AN to it.
never got around to use it but its a way of doing it.
__________________
André
2009 Chrysler 300C Touring.
3.0 liter V6 diesel, five speed auto.
1968 Chevelle Coupe.
355cid, Viper T56, Corvette C4 IRS (Dana 44) and C4 IFS. Porsche 6 and 4 piston Brembo's.
1980 Chevy Van (shortie G10).
355cid, TH350, 8.5" 10bolt posi and Belltech spindles.
*NOW PARTING OUT* 2000 BMW 540i Wagon*
Bikes
1968 Benelli City Bike
1990 Yamaha RD 350
1990 Yamaha TZR 125R
1991 Yamaha TZR 125R - RD350 engine, Aprilia RSV forks, RS250 wheels and shock
2010 Buell XB12SS
I was planning to use a T5 bellhousing with the attached slave so I cut the quick connect and silver welded an AN to it.
never got around to use it but its a way of doing it.
Thats what I will do if I cant find this... I think it may have been a new hose that has has the AN fitting already installed.
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Using aftermarket Hydraulic Thowout bearing
Linear Mode
