Vaporworxs Tank

[DKz Garage]

I have a Rick's Vaporworx with the 5th gen Camaro GM fuel pump w/internal pressure reg:I am trying to calibrate my Dakota Digital fuel gauge...does anyone know the ohms on the sending unit that Ricks uses?
Nobody at Ricks could give me a "for sure" answer.

Thanks!

[Mkelcy]

I'm not sure this is what you're asking, but the range of sender that's part of the Gen 5 in-tank pump is 33-240 ohms.

[DKz Garage]

Originally Posted by Mkelcy

I'm not sure this is what you're asking, but the range of sender that's part of the Gen 5 in-tank pump is 33-240 ohms.

Thanks. I edited my post. I am looking for the ohms on the sending unit

[Mkelcy]

Originally Posted by classiccamaro

Thanks. I edited my post. I am looking for the ohms on the sending unit

Which I provided.

[130fe]

yeah, depends. Are you using the 5th gen fuel sensor (part of the fuel pump assembly) or one mounted separately? I know Carl C posted some info on how to integrate the 5th gen sender. My vaporworx tank uses one of the separately mounted 0/90 tube senders. Mike is correct about the 5th gen sender specs.

[DKz Garage]

Originally Posted by Mkelcy

Which I provided.

Thanks Mike....

Originally Posted by 130fe

yeah, depends. Are you using the 5th gen fuel sensor (part of the fuel pump assembly) or one mounted separately? I know Carl C posted some info on how to integrate the 5th gen sender. My vaporworx tank uses one of the separately mounted 0/90 tube senders. Mike is correct about the 5th gen sender specs.

How can you tell which sending unit you have?....I put the tank in and it's hard to see above the tank at this point. It seemed to me the sending unit was separate from the fuel pump...I suppose I could try the two different ohm settings on the Dakota digital and see which one works?? 0-90 and then 33-240. I know there is only about a gallon of fuel in the tank at this point.