Painless wiring question...

[MaxHarvard]

has anyone used this before? How hard is it to wire up? does it work well? I'm running out of room for 12v hot and key-on hot wires.

Please, any help would be good!!

http://www.jegs.com/webapp/wcs/store...20007_-1_39983

[XcYZ]

Eric, check out American Autowire. They might have something that will work for what you need.

edit: Found the link:

http://www.americanautowire.com/prod...ccessories.cfm

[MaxHarvard]

Can you tell me which one you were looking at?

Whats the difference? I need one with 12v Key-on and 12v constant HOT.

[XcYZ]

In that case, you'll want one with 2 busses, American Autowire's accessory blocks have one. You could use two accessory blocks, one for 12V constant and one for 12 V ignition. I see that the accessory blocks from Painless are setup with 2 busses.

[kennyd]

painless is a easy to use harness .
are you talking about at the key ? thats where you are running out of wires ?

[MaxHarvard]

Originally Posted by kennyd

painless is a easy to use harness .
are you talking about at the key ? thats where you are running out of wires ?

I'm talking about 12v sources that need the key to be in the ON position, and some sources (like the CD player) need a constant 12v source when the key is in the OFF position.

[kennyd]

ok i understand . i set up a relay on a junction block for keyed wires and run a constant junction block for non keyed 12v .
i like painless harness , but i have a AAW set up for the 57 i will see how i like it .