there just reg old hookers, that i welded 2 bolt flanges on, i threw them in the deal when i sold vinny my 496, and the exhaust is 3 inch oval with oval x pipe oval muffler to 3 inch round tailpipes,heres a sound clip link and pic http://picasaweb.google.com/JakeParr...65697738889026
Looks real nice Jake and Vinny!! Color, stripe, wheels ..all of it. You stuck it out there with the blue wheels but I think it works!! Nice to see something different!!
sure do, clears by say 1/2 when fully lowered not as if he could and or would drive it that low, mufflers isolated and tails hard mounted, got 1 to 1.5 inches off bags and the closest is the pipe to the outlet on the carb version of ricks gas tank, i got exhaust wrap just to make sure. you take stock style tailpipes, cut the vertical so you can clock the over the axle portion to go straight back towards fuel tank, then make a 90 towards outside of car, then another 90 to rear tail panel, basically almost identical to the ones i made to clear the quadralink, of course this works with stock style tubs and non notched frame, his axle is about resting on the frame when fully lowered and the tailpipes are like 1/4 off upper air bar brackets.
these pipes work with stock width fuel tank, you would need narrowed tank but same design would work for mini tub, you just would not go towards outside of car as far
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Linear Mode
