My Cuda project is up at Race Rodz !!

[DRJDVM's '69]

Nothing major to show via pix. Chris has made quite a bit of progress, but nothing exciting to show via pix.

We're still working on the design for the inner fenderwells. Goal is to clean things up, open some room but retain some of the factory look. Heres some of the design so far. We tried a big flat design with no bead roll and it looked wierd. What do you guys think of the beadroll design??

The first one... I though the upper areas was too big, so we scaled that down..


This is the next version where the top section is smaller and the beadroll isnt as deep. This piece will be rolled over and then a "shelf" will be created similar to the stock look....



This is stock for reference..