Machined Stainless Steel hardware from Ring Brothers

#10

02-04-2008, 07:51 AM

Steve1968LS2 Steve1968LS2 is offline

Moderator

Join Date: Feb 2005

Location: Anaheim Hills, CA

Posts: 5,534

Thanks: 0

Thanked 4 Times in 2 Posts

That's a lot like what I use except the washers are "deeper". Very nice. What do the back sides look like?

The perfect design would have a small raised disc on the back to help paint deformation remain unseen. Mine are flat on the back.

Also, what is the rough cost per a washer?

They sure make sweet stuff.

__________________
"A ship in port is safe, but that's not what ships are built for."

See Bad Penny run the cones: https://www.youtube.com/watch?v=8GUPPIX-92U

1971 Chevelle Wagon - Roadster Shop Chassis ProCharged Shafiroff LS and lots of yada yada

1968 Camaro - Project Track Rat - 440 RHS LS

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -7. The time now is 12:54 PM.