thanks all Press fit is around .001" to .0015" - the holes were a bit out of round once I got the UBJs out so I measured with a bore mic until I found the min and max diams, took the average with the assumption the hole will become round again after I press in the parts, and shot for .001" minimum.
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Press fit is around .001" to .0015" - the holes were a bit out of round once I got the UBJs out so I measured with a bore mic until I found the min and max diams, took the average with the assumption the hole will become round again after I press in the parts, and shot for .001" minimum.
Threaded Mode