1969 Camaro tru-turn

[Rod P]

it has been a pretty good info thread, some complaining now and then but, I have tried to gather as much info as I can get, while still performing at work, this morning I grabbed spindles, tape measures, tools and set out to get some measurements that many said they wanted on the frame and mounting surfaces

so spindles first......stock vs. RideTech Drop, as you can see other than the RideTech spindle being taller the build dimensions are the same...


the snouts line up


the bearing surfaces line up


the the ball joint mounting location is the same


so the wheel is not moved out or in from stock spindle locations


next is frame measurements.....hold on