Well after a good 30 hours or so of work. The bottom of the subframe is smoothed also. Completly welded entire factory seam, cut filler plates, weld them in, grind for a few days, weld and fix imperfections, grind a few more days, do that a couple times till you get it pretty close. I'll be putting it in primer this week to start the mock up. After car is mocked up it'll come back out, imperfections and stuff will be leaded then powder coated. Not to sure I'll ever do this again!!
Start by welding up factory seam!!
yep the whole seam!!
Fab up your filler plates and tack them in
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Threaded Mode