What is the best way to remove undercoating?

[rallye455]

Thanks for the replies guys....looks like another messy project.

[G_T]

You can bruch on adhesive remover - you can buy that from home depot by the gallon. Just let it set for a while and scrape it off. Nasty mess.

If you have it on a rotisserie, then I'd suggest renting a power steam cleaner/washer. You can just blast away the undercoating/etc. works really well

[69NBC]

Just tried a propane weed burner and plastic paint scrapers. Scraped off like Butter! The scraper eventually lost its edge due to heat so it requires 2 or 3 per wheel well. Finished one well in less than an hour. Best of all the the debris got hard again right away and swept right into a dust pan.

[MarkM66]

I use an air hammer with a flat edge. Chipped right off.

Got the hard to reach areas with a wire wheel.

[tazzz2_ca]

They say this tool cuts through it like butter and is great......I haven't personally used one but I am considering the purchase of one for my cars......

http://buy1.snapon.com/catalog/item....re&dir=catalog

[MarkM66]

After just finishing mine, I'll never not have it blasted off again. It takes to much time and is a total PITA, no matter how you do it yourself.