Pacific Anodizing in Fresno can strip them for you. I send parts to them all the time. I anodize AN fittings all the time to get all the fittings the same color. There are a bunch of odd fittings that they do not make in black yet.
It is best to send a mass amount of stuff to be anodized, cuz the minimum charge if for quite a bit of stuff. I just did about 20 various fittings off a project and the charges me 60 bucks. soit was like 3 buck a piece. ( more then the cost of some fittings ) I sent in a bunch not to long ago, big and small stuff (motor mounts, engine pullies, tons of fittings) and it was like 120 dollars.
For a bright anodized finish you can polish and then anodize them. It gives at a really cool look.
Rodger
Last edited by ironworks; 09-17-2008 at 09:33 AM.
|
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
fuel rail
Hybrid Mode
