New Guy from Ga.

[ratty 46]

Thannks guys.

I sold a pro street 66 chevy II & my 62 Ford Uni to fund this build. The 66 is out in Tx now racing & the uni went local & is a daily driver.

I've made more progress in removing some of the original X members - which will be replaced with new tubing.

Here's a shot of the cherry front end.

I'm trying very hard to have this done for the april Fla. Billet Proof get together. We shall see!!



It's a fun project...... so far & should be very unique when finished.

Unlike most of the cars here on this forum with slick paint - mine is actually done paint wise.

Ratty 46

[ratty 46]

After removing & selling off the front & rear suspension, engine, trans & torque tube along with the wheels & tires it was cutting time.

So far I've removed the front & rear suspension X member mounts along with the center part of the X member.
My intention is to install some fab'd C channel to run on each side parallel to the frame back into the remaining X member. I'll be using this as the side mounting point for my front 4 link setup, driveshaft loop, trans mount & possibly an addt'l brace for strenght.

I also scored a Currie built 9" third member with 4:11 gears & a detriot locker.

So...... as soon as I get the "C" channel I'm back in biz & moving forward.









Ratty 46