Anyone using Heidts or Competition engineering subframe connectors?

[66LS7]

I am using the Heidts connectors on Re-Peeled my 70 Camaro project. They are closer to the floor than the competition ones & are not as tall.

Randy(D&Z Customs LLC.)1-262-347-9741

[mazspeed]

I had the Competition Engineering, they were ok, they did hang too low, but really did help the car stiffness wise. The DSE's were the ones that made the huge difference.

[thedude327]

Originally Posted by 66LS7

I am using the Heidts connectors on Re-Peeled my 70 Camaro project. They are closer to the floor than the competition ones & are not as tall.

Randy(D&Z Customs LLC.)1-262-347-9741

Randy,
Could you post some pictures of the subframe connectors on your car to give an idea of how they look installed ?

Thanks
Paul

[66LS7]

I will see what I can do.


Randy(D&Z Customs LLC.) 1-262-347-9741

[Heidts#14]

hold that thought Randy...........

Getting pics up asap

[Heidts#14]

Lets try this one

[thedude327]

Thanks for posting the pic of the subframe connector install. Seeing it gave me another question though. The mounting bolts at the rear of the connector that go up into the rear frame rail, are they going through existing holes in the rear rail section or drilled through the rail and up into the floor ? Oh and do you have some side profile shots with the car on the hoist ?

Thanks for any help with this.
Paul

[Heidts#14]

In the 2nd gen frames there are actually existing holes that you feed a U bolt through that holds the bracket to the frame. I will get some more pics up asap