70 Cuda

[HWY Nova]

Mark,

Looks like you are a great cardboard-cutter-outer!


All,

I saw this car last week at Mark's shop. It looks even better in person.


--Eric

[bentfab]

Originally Posted by HWY Nova

Mark,

Looks like you are a great cardboard-cutter-outer!


All,

I saw this car last week at Mark's shop. It looks even better in person.


--Eric

Eric here's a couple more pics of my professional fabricato-cardboard-cutter-outer technique's. If you measure write on the cardboard the metal comes out looking ok. Check it out !!!

[ironworks]

You know cardboard is lighter then steel.

So when are we going to cut out those rails?

[wiedemab]

Nice work!

I have to say - damn you have a serious collection of vise-grips and clamps. That slat wall works pretty good for tool organization too. I'll have to keep that in mind.

[bentfab]

Originally Posted by ironworks

You know cardboard is lighter then steel.

So when are we going to cut out those rails?

Roger,

I told you to not let the cat out of the bag. Just don't tell anyone about my new welder that can weld the two together. Lincoln 250 Card-Board-O-Matic w/ pulse option.

I think these rails I'm cutting in-house. To simple !!

[Kendall Burleson]

Man I thought I was the only one who had one of those machine. Roger how much heat do you used on the green tape wire?

[bentfab]

Finally a couple more pics. Got the pass. frame rail,exhaust cut out, and front arm pocket done. All this cause the customer wanted side exhaust. So I had to figure out how to make this thing into a brick house and still let the exhaust out the side.

[customcam]

Very cool and Clean man Did you try to talk him out of the side exhaust?