My Cuda Project Part II...now at Bruning Auto Design - Lateral-g Forums

tjbruning · #1 05-07-2009, 07:58 AM

Quote:

Originally Posted by bentfab

This is with a 19 out back. I personally would like it a little lower but that's what the owner want's. These cars are a little tricky to make look right.

I agree on going a bit lower, but then again I like em' low!

19/20 combo

edit - Tim built a custom oil pan that doesn't hang below the car/chassis, so no less than 5" ground clearance at this height...

CAMAROBOY69 · #2 05-07-2009, 08:00 AM

Now that stance looks perfect.

**tones2SS** · #3 05-07-2009, 11:40 AM

Quote:

Originally Posted by CAMAROBOY69

Now that stance looks perfect.

I agree.
Looks killer!!

bentfab · #4 05-07-2009, 11:29 AM

Quote:

Originally Posted by Bruning Auto Design

I agree on going a bit lower, but then again I like em' low!

19/20 combo

T.J.
When I was first setting up ride hight I showed the customer those same pics. Problem is he's a little old school and likes them sitting a little higher.

Buy the way your car is BAD A$$ !!!!!

tjbruning · #5 05-07-2009, 12:06 PM

Quote:

Originally Posted by bentfab

T.J.
When I was first setting up ride hight I showed the customer those same pics. Problem is he's a little old school and likes them sitting a little higher.

Buy the way your car is BAD A$$ !!!!!

Thanks Mark! Sounds like your customer is coming around for an "old school" kinda guy considering what your doing with his Cuda. Nice fab work as usual - looking forward to seeing the finished build.