Anvil carbon fiber radiator closeout panel for 1st gen Camaro

[Vegas69]

I like how it covers up the top of the radiator support but allows access to the front of the support for remote mounted resorvoirs. Hmmmm, no carbon fiber on my car but that may change soon.

[redfire69]

Looks really good. Any ETA on the CF inner fenders?

[Teetoe_Jones]

69 Inner fenders are in stock in both 100% carbon, and carbon/fiberglass; we have the satin and glossy finishes in both units.

Tyler

[MODO Innovations]

Very, very nice. Great job.

[ANVIL1]

Originally Posted by Vegas69

I like how it covers up the top of the radiator support but allows access to the front of the support for remote mounted resorvoirs. Hmmmm, no carbon fiber on my car but that may change soon.

Don't forget, kids, you can always paint carbon fiber any color you want. If you want to leave a little carbon fiber exposed you can mask it off and paint the rest for a custom graphic treatment. All you need to do is block out the part with 320 sandpaper, then finish with 400-600. Just enough to give the paint a little "tooth", but not too much to show sand scrathes when you're done. Clearcoating the whole thing when you are done will keep it looking good and is highly recomended for partially exposed carbon areas. All of Anvil carbon fiber parts aleady have a clear coat on them with UV protection, but if you sand through it, you will want to use a clear with UV inhibitors in it.

[Vegas69]

That's what I was thinking Matt. Carbon fiber really doesn't fit my theme.

[Teetoe_Jones]

Originally Posted by Vegas69

That's what I was thinking Matt. Carbon fiber really doesn't fit my theme.

But it would look sweet if you painted the closeout black and left the word Payback in bare carbon. Think about it.

Operators are standing by.

Tyler

[Vegas69]

As soon as my wallet is done being chapped by this engine build we'll make a deal.

[XcYZ]

That's a nice piece.