Weatherstripping

[Musclerodz]

Originally Posted by chr2002ca

I tried the 'Premium Latex' weatherstripping(no, not the condoms) from Classic Industries(OER) and they did make it much easier to close the doors and windows versus the rubber ones I initially installed, however after about 6 months these Latex ones have started cracking all over the place. My car is kept in a temperature controlled garage so there's no reason for the cracking other than product quality. My guess is that the Latex doesn't like the light stretch necessary to install them and very quickly it starts shearing apart. I can't recommend them. I will probably go back to a quality rubber replacement and just get use to the door slam.

I have never had to slam a first gen door with Metro

[canrc]

Thank Guys! Metro it is.

Mike do you sell the Metro stuff?

[Musclerodz]

Originally Posted by canrc

Thank Guys! Metro it is.

Mike do you sell the Metro stuff?

yes, it is listed on our website, or you can call me.

[chr2002ca]

Originally Posted by Musclerodz

I have never had to slam a first gen door with Metro

Is that with the window up and a good tight seal on the glass(no gaps)? You promise?

If yes, my next molding will be Metro.

[ProTouring442]

Originally Posted by chr2002ca

I tried the 'Premium Latex' weatherstripping(no, not the condoms) from Classic Industries(OER) and they did make it much easier to close the doors and windows versus the rubber ones I initially installed, however after about 6 months these Latex ones have started cracking all over the place. My car is kept in a temperature controlled garage so there's no reason for the cracking other than product quality. My guess is that the Latex doesn't like the light stretch necessary to install them and very quickly it starts shearing apart. I can't recommend them. I will probably go back to a quality rubber replacement and just get use to the door slam.

Odd about the cracking... the factory stuff was latex. Have you contacted the manufacturer?

Originally Posted by chr2002ca

Is that with the window up and a good tight seal on the glass(no gaps)? You promise?

If yes, my next molding will be Metro.

We used Metro on my Dad's '56 Chevy, and it was stiff as hell at first. Once it compressed a bit, no more problems.

Shiny Side Up!
Bill

[chr2002ca]

Originally Posted by ProTouring442

Odd about the cracking... the factory stuff was latex. Have you contacted the manufacturer?

Yep, that's what I plan to do next time I visit Classic Industries since it's their product brand(OER). I'll take some pictures and show it to them and see what they say. They've always been good to me there so I'm sure we'll figure something out. Thanks for confirming the Metro product also.

[Musclerodz]

Originally Posted by chr2002ca

Is that with the window up and a good tight seal on the glass(no gaps)? You promise?

If yes, my next molding will be Metro.

I promise or i will buy them back

[chr2002ca]

Originally Posted by Musclerodz

I promise or i will buy them back

Sounds good. Thanks for the reassurance.

[geberhard]

Godo info. I just redid my 67 and unfortunately was naive and went with OER. what a POS! slamming the doro sucks and only being able to open puching hard from outside.

I am replacing the door seals with SoffSeal, just ordered last week; wish I had seen this post earlier and the info on Metro and Musclerodz as a cool vendor. I will report back on how my re-install goes.

[Rybar]

Good info, I have OER and have to slam the crap out my doors. I hate it. Raj maybe we should do a 2 person group purchase lol