Rear 9" assembly help - Lateral-g Forums

John510 · #1 02-29-2012, 07:18 PM

Fab 9 rear with Moser axles (big ford ends)

First time putting one together sorry for the dumb questions.

Should my axle bearings be sticking out 1/8"?

Once the axles are in Im assuming the c-clips bolt to the housing to hold the axles in right? What holds the brakes on?

youthpastor · #2 02-29-2012, 07:20 PM

Quote:

Originally Posted by John510

Fab 9 rear with Moser axles (big ford ends)

First time putting one together sorry for the dumb questions.

Should my axle bearings be sticking out 1/8"?

Once the axles are in Im assuming the c-clips bolt to the housing to hold the axles in right? What holds the brakes on?

Yep that is correct about an 1/8. What brakes do you have? Normally Baer brakes and others use the axle retainer as the backing plate, you ditch the 4 hole retainer and use the backing plate- hope that helps John

John510 · #3 02-29-2012, 07:23 PM

Quote:

Originally Posted by youthpastor

Yep that is correct about an 1/8. What brakes do you have? Normally Baer brakes and others use the axle retainer as the backing plate, you ditch the 4 hole retainer and use the backing plate- hope that helps John

I have Baer 6S for the rear. Ill open that box today and see if there is instructions.

Thanks

Ron in SoCal · #4 02-29-2012, 08:20 PM

John - PM me and I'll get you there...

John510 · #5 02-29-2012, 11:35 PM

Hey guys do I need the 1/2" or the 3/8" T-bolts for my housing ends?

Was trying to order some but not sure which size I need. Thanks for the help.

Ron in SoCal · #6 02-29-2012, 11:42 PM

PM sent...

Blake Foster · #7 03-01-2012, 10:13 AM

Normally Bare brakes use a socket head cap screw to mount the bearing retainer, not the T bolts. with this you will most likley have to clearance the housing end for the bolt head. be cautious not to grind to far and break through the housing end.

Bryce · #8 03-01-2012, 11:08 AM

I think the FAB9 housing has tapped housing ends. At least mine does.

John510 · #9 03-01-2012, 01:39 PM

Quote:

Originally Posted by killer69

Normally Bare brakes use a socket head cap screw to mount the bearing retainer, not the T bolts. with this you will most likley have to clearance the housing end for the bolt head. be cautious not to grind to far and break through the housing end.

I finally found my instruction manual. It says to use the 3/8" original T bolts. Time to order some today so I can finish assembly.

Blake Foster · #10 03-02-2012, 10:44 AM

lol When in doubt................. Read the directions