This is MY 67 Camaro - Lateral-g Forums

Roberts68 · #1 08-14-2012, 07:53 PM

Hanging in there Chief?

It has been a little while. I was thinking of your thread while I was cleaning the jute and grime off my floor to prep for POR15 and thermocoustic barrier.

So... I had to look you up and wish you well.

Sonar Chief · #2 08-14-2012, 08:04 PM

Quote:

Originally Posted by Roberts68

Hanging in there Chief?

It has been a little while. I was thinking of your thread while I was cleaning the jute and grime off my floor to prep for POR15 and thermocoustic barrier.

So... I had to look you up and wish you well.

I am doing well ... my boys (young men) have been with me visiting before going back to college so the car was on hold while I spent time with them.

They flew home this morning so I'm back on track ... after I clean the house post boys

Sonar Chief · #3 08-25-2012, 02:47 PM

Well mark the wheel wells off the list, after being on the road for some time I got in the garage last nite and finished welding the other well and then today I got both ready for some epoxy prime (what a mess!).

Not too exciting but they had to get done the right way! Hopefully I can get some primer on them next weekend, I am going to tackle the firewall and get those side cowls mocked in and ready for welding.

My dealer had to send pictures back to AMD cuz the driver's side didn't fit ... they didn't know they had a problem with the stamp until I called them, go figure

I know what I have to do to make them fit to my liking so that's what I'll do

Little filler and all better!

About wore out my fiber disc on the undersides!

Have to go and do some homework now ... more to follow.

**waynieZ** · #4 08-25-2012, 03:17 PM

Nice work they should last another 45 years.

Steve68 · #5 08-26-2012, 04:38 PM

Nice chief!!!

was wondering what you were doing,

coolwelder62 · #6 08-26-2012, 05:50 PM

The project is really lookin good.And the welds on the iner fender's will prob. work great.It's hard to the mig too lay down perfect after the panel has had that must rust on it for that long.It easy to get the perfect spot weld on a super clean rust free panel.You are doin an awesome job.Way more then most folk's would to the trouble to DO!!!!!!!!!.