Nova Suspension

[Blake Foster]

Originally Posted by drednot

Hey Blake, First off You guys built a couple of my favorite Novas. I have looked at Speedtech and it does look like great stuff, but honestly I am a DIYer and on a budget. I can weld the little tabs on my rearend for the CA/Ridetech systems. Speedtechs torque arm looks like it is over my skill level to weld the brackets on, so I would have to farm that out (no one around here will do it) or buy a new rearend driving the cost up and up. t looks to me like your systems are quite a bit more, which is OK, but I am on a budget and this isn't going to be an all out competition vehicle. Same with DSE stuff, over my skill level and too expensive to have the one guy in town who can do it do it. I would be all for ATS spindles and Speetech arms tho...

if you can hold the torch and a tape measure you can weld the 4 tabs 9 if it is a 9") 3 on a 12 bolt on for the Torque arm rear end. the upper X member welds in as well total of 6" of welding so you should be able to handle that as well, then it is bolt in. We supply the drawings for the rear end bracket placement.
Our torque arm is 1999.00 complete, if you want Ridetech single adjustables it is 2249.00 so 300.00 more than Ridetech.
Glad to see you feel our Torque arm is more of an all out competition set up.